Filter
Top Products
143
5. Remarks
Do's and Don'ts
R
CAUTION:
Important
❒ Only disconnect the power cord after checking that all copies are finished.
• Do not touch areas on or around the fusing unit. These areas get hot.
• After making copies continuously, the exposure glass may feel warm to
the touch. This is not a malfunction.
• Make sure the machine is well ventilated when in use. If the machine is op-
erated for a long time in a poorly ventilated location, it may begin to smell.
We recommend that you use the machine in a well ventilated room to en-
sure you maintain the operating conditions.
• You might feel warm around the ventilation hole. This is caused by ex-
haust air, and not a malfunction.
• Do not turn off the operation switch while copying or printing. When turn-
ing off the operation switch, make sure that copying or printing is complet-
ed.
• Do not open the covers of machine while copying or printing. If you do,
misfeeds might occur.
• Do not drop staples, paper clips, or other object in to the machine.
• Do not stand or sit on the machine.
• Do not leave the paper path section open for more than 10 minutes.
• Do not touch the photosensitive conductor. If you touch it by accident,
wipe it gently with a soft cloth.
• If you will not be using the machine for a long time, remove the paper from
the paper roll tray and place it in its storage bag.
• The machine might fail to produce good copy images if there should occur
condensation inside caused by temperature change. To prevent such trou-
ble, this machine has an anti-condensation function. Even after the main
power switch is in the stand-by position, the anti-condensation heater is
active, thus keeping the machine body slightly warm.
• The machine has a Anti-humidity function. Even when the main power
switch is in the Off position, the Anti-humidity heater is active if it is
turned on.
• Do not move the machine while copying or printing.
•
Unplug the power cord from the wall outlet before you move the equipment.
While moving the equipment, you should take care that the power cord will
not be damaged under the equipment.