Filter
Top Products
1
Guide to Components
❖
❖❖
❖ Front
1. Original output (upper)
When original output (upper) is se-
lected, the originals are stacked here
after they have been scanned.
2. Operation panel
This is used to set function settings,
and the indicator indicators indicate
the status of the machine. See P.6 “Op-
eration Panel”
3. Original cover
This protects the original feed mecha-
nism and the exposure glass.
4. Original cover release lever
Use this lever to open the original cov-
er to clear original jams or for clean-
ing.
5. Front output auxiliary tray
Receiving copy paper output, this is
used to load originals on rolled paper
too.
6. Main power switch
Use this turn the main power on or off.
If you will not be using the machine,
disconnect the power cord. Normally
the machine should be left on.
7. Upper tray
This stores paper roll 1 (front) and pa-
per roll 2 (rear).
8. Lower tray (option)
This stores paper roll 3.
9. Operation switch
Use this to turn the power on or off.
The power indicator is lit when the
power is on.
10. {
{{
{
Scanner Stop
}
}}
} key
Use this key if originals are fed at a
slant, or if you want to cancel scan-
ning while an original is being fed into
the machine. You can also use this to
release the paper edge hold function.
ZEDH320E
1
2
7
8
9
10
3
4
5
6
11
12
13
14