Filter
Top Products
Notes Concerning Transmission
1.
2.
3.
Displays
REDIAL STANDBY
If the line is busy or contact is impossible, the
READY 100%
1130
number is automatically redialed up to 2 times
REDIAL
STANDBY
at intervals of 5 minutes. (Call for service to
change these redial parameters if necessary.)
“REDIAL STANDBY” is displayed during the in-
tervals. To cancel redialing, remove the docu-
ment from the feeder as explained in section
11-1.
If communication is still impossible after all redial attempts, the machine will ask you
for another number.
Note:
You can redial
8-17.
immediately by pressing Pause/Redial if required. See page
TRANSMISSION STANDBY
If a message is coming in at the same time as
SAN JOSE
OFFICE
you press Start,
“TRANSMISSION STANDBY”
TRANSMISSION
is displayed below the sender’s RTI. Your docu-
STANDBY
ments will be automatically transmitted immedi-
ately after the end of reception.
Error Report
If transmission fails, an Error Report will be printed. Keep this; it may help the service
technician. Error codes are explained on page 11-4.
Reduction
If the paper in the receiving terminal is not wide enough for the document you are send-
ing, the machine will automatically reduce the data so that it will fit.
The machine will change the resolution from standard to detail automatically.
If you wish to have the choice of overriding au-
SAN
JOSE OFFICE
tomatic reduction and transmitting the data as it is,
A3––-A4
TRANSMIT
contact your service representative,
7-6