Filter
Top Products
One of the following messages will be briefly displayed.
PROGRAMMED – the number has been stored into the group.
ALREADY IN GROUP – this number is already in this group.
CLEARED – this number has now been taken out of this group.
# NOT PROGRAMMED –
no telephone number has been allocated to this key or
code.
NOT IN GROUP –
the number that you wanted to clear was not in the group.
LONGHAND #’s FULL – you tried to program a full telephone number into the group
but there are already ten telephone numbers used in groups.
Either delete an unwanted telephone number from all the groups, or program the new
number as a Speed Dial code or Quick Dial key (mode 60) before storing it in a group.
8) The machine automatically returns to step 6.
GROUP NO 1
KEYPAD
I
~
OUICKISPEEDf KPAD ,
9-10 Setting the Polling ID Code
This four-digit code is necessary for polling and transfer request.
All concerned parties should decide on an ID code before transmission as, if their codes are
not identical, the operation will fail.
Note: Digits O to 9 and letters A to F can be used.
Do not use 0000 or FFFF.
1) Press the Function key and enter 62.
I
I
MODE NO 62
YIN
I
I
I SET ID CODE?
2) Press Yes.
I
—.
ID CODE
KEYPAD/Y
I
0000
—
I
3) Enter a four-digit code at the keypad. e.g., 01 2A.
~
I
KEYPAD/Y
I
. Usekeys 0—9and A—F.
ID CODE
KEY PADIY
I
PROGRAMMED
I
4) Press Yes to store the displayed code.
Function 63 starts automatically.
MODE NO 63
Y’
I SET RTl~
I
9-14