Filter
Top Products
7) After entering all destinations, press Start.
The document WIII be scanned and stored in the memory. The Remaining Memory indica-
tor will count down as the message is stored. A New File Report will be printed after the
message is stored The machine then returns to standby (unless you selected Immediate
transmission, in which case the message will be sent now) Do not switch the power off,
or the memory WIII be erased. After transmission, a Memory Transmission Report ISprint-
ed
Caution:
While the terminal IS scanning the document, do not leave the machine
If one of the following symptoms occurs,
your document was not stored
completely:
● MEMORY OVERFLOW appears on the display until the machine returns
to standby.
c No new file report is printed.
There are no other indications of memory overflow, so you should keep a
close watch on the machine during storing,
Notes:
1 Redlaling
In memory mode, a terminal can be redialed up to 4 times (at Intervals of 5,
5, 10, and 5 minutes). After each failed redial attempt, the Caution Indicator
flashes and the machine asks you to press Stop
After all redialing attempts fail, a Memory Transmission Report and an Error
Report are printed and the message is erased from memory
To cancel redialing, erase the document from memory with function 67
2 Page Retransmission
If ECM is enabled (function 83), any parts of a page that were not sent cor-
rectly will be resent automatically If ECM is not enabled, the complete page
will be resent; the maximum number of retransmission attempts w 2 but this
can be increased to 3 by service.
3. Restrictions
Maximum number of addresses per file: 100
Maximum number of files: 99
Maximum total addresses in all files: 300
Note that the total number of addresses stored in the machine for polling re-
ception and memory transmission, when added together, can not exceed
300,
4. Memory Standby
This is displayed if a message is coming in at the same time that you
pressed Start. Your message will be stored after the end of reception
7-9