Filter
Top Products
Or:
Enter a preprogrammed group of receiver numbers
(e.g., Group No. 1).
i) Press
●.
TRANSFER TRANS
MODE
**
KEYPAD
Groups Label
ii) Enter 1 at the keypad.
{
DISTRIBUTORS
Note: Entering O (zero) will cause you to transfer
**.
to all terminals In all the groups (1 – 7).
Take care not to enter O unless so desired.
YN
iii) Press Yes (or press No to correct),
TRANSFER TRANS
MODE
OUICK#D * KPAD START
)) Either:
Enter another receiver number or group of num-
bers; go back to step 8
Note
Do not enter more than 30 receivers for
one transfer operation
Or:
If all required receivers have been designated,
NEW YORK OFF{LE
press Start
DIALING
Jotes: TRANSFER TRANS NIA
If this is displayed, the designated broad-
caster cannot transfer your message (its
memory may be full, or it may not have
the transfer function)
The broadcaster will be redialed after 5
minutes.
TRANSFER STANDBY
This means that a message was being received when you pressed Start. Then
“TRANSFER STANDBY” is displayed. Transfer will start after the end of recep-
tion.
8-7