Filter
Top Products
BEFORE OPERATING THE PROJECTOR
About Copying
When using the Slide Film Holder
When using the Strip Film Holder
Available film area for
copying
::-
~1
~[~;[
21.5 mm
I
The copy size when Full
-
Size is selected.
;
.;~;
;; -~1
124
mm
I
I
~ 19:6Tm -M
1
I
I
~ *o;,8T” ~
I
, I
~ A black line might appear on the edge of copies, This
line is caused by the holder or the edge of the film.
Black line
+Tl
?
::;:.:~<:::~fi.yt~~.~fi+f
.......................................................
.......................................................
.:.~.:.:.:.:.w.:.:.:.:.:.:.:.?..
.................................................../
IJ As the fresnel lens is used, a ring pattern on the center or
o...........................-..
:.:.::::::::::::::::.:.:.:.:.:.:.:.:.:...............:..<
~::.:.>~:.~.:.~.:.:.:.:.:.:.~<
..................................+
:.:.::::::::::::::::::::::::::::::::::::::~:*..
............................................,
moire pattern might appear on the copy image.
........................
.................................
5.........................................................
~::*:::::::~.:::::::;.::f
.:.~.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.:.>
.............................................,.............::...................*
1
1
Notes For Operation
IJ
c1
c1
IJ
c1
c1
IJ
IJ
IJ
n
c1
IJ
c1
c1
First, you must perform shading to get the projector to register the condition of the film, This way, the projector
can adjust the light intensity automatically while copying.
You can adjust the color balance and color density manually.
This projector has an automatic focus function, but if you use the glass mount film holder, adjust the focus
manually,
The shading method differs depending on the type of film (negative or positive). When making copies from
a positive film, make sure to set the film after shading.
The filter and the way to set it differ depending on the type of film,
If you want to clear the data you just entered, touch the Cancel key. The screen returns to the previous page.
If you want to go to the next page, touch the Exit key,
If you are finished using the projector unit,
press the Clear Modes/Stand by key.
Do not forget to turn off the power switch of the projector when you are
not using it,
Do not obstruct the light path from the projector. If the light path is obstructed, the image might not match the
original,
The shading adjustment is very sensitive, so after the shading operation the mirror unit must be kept perfectly
still. Do not move it or allow vibrations to interfere with it. If this happens during copying, lines might appear
on the copy. In that case, you must perform shading again.
To avoid the above problem, avoid touching or leaning on the copier or the projector after shading. Do not
put anything on the copier while it is operating.
If you need to open and close the doors (to clear a jam or add toner), we recommend that you perform shading
again aftetvvards.
Avoid multi-wiring. The projector should be connected to a power source as described on the inside of the
front cover.
10-5