SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
A
CCESS
C
ONTROL
L
ISTS
3-87
CLI – This example shows how to create an Ingress MAC ACL and bind
it to a port. You can then see that the order of the rules have been changed
by the mask.
Binding a Port to an Access Control List
After configuring the Access Control Lists (ACL), you can bind the ports
that need to filter traffic to the appropriate ACLs. You can only bind a port
to one ACL for each basic type – IP ingress, IP egress, MAC ingress and
MAC egress.
Command Usage
You must configure a mask for an ACL rule before you can bind it to
a port.
This switch supports ACLs for both ingress and egress filtering.
However, you can only bind one IP ACL and one MAC ACL to any
port for ingress filtering, and one IP ACL and one MAC ACL to any
port for egress filtering. In other words, only four ACLs can be bound
to an interface – Ingress IP ACL, Egress IP ACL, Ingress MAC ACL
and Egress MAC ACL.
When an ACL is bound to an interface as an egress filter, all entries in
the ACL must be deny rules. Otherwise, the bind operation will fail.
Console(config)#access-list mac M43-133
Console(config-mac-acl)#permit any any3-134
Console(config-mac-acl)#deny tagged-eth2 00-11-11-11-11-11
ff-ff-ff-ff-ff-ff any vid 33-134
Console(config-mac-acl)#end
Console#show access-list3-146
MAC access-list M4:
permit any any
deny tagged-eth2 host 00-11-11-11-11-11 any vid 3
Console(config)#access-list mac mask-precedence in3-137
Console(config-mac-mask-acl)#
mask pktformat ff-ff-ff-ff-ff-ff any vid
3-138
Console(config-mac-mask-acl)#exit
Console(config)#interface ethernet 1/123-1
Console(config-if)#mac access-group M4 in3-142
Console(config-if)#end
Console#show access-list
MAC access-list M4:
deny tagged-eth2 host 00-11-11-11-11-11 any vid 3
permit any any
MAC ingress mask ACL:
mask pktformat host any vid
Console#