![](http://pdfasset.owneriq.net/6/90/69029205-8bce-4051-bf2a-3f7a074bd3a4/69029205-8bce-4051-bf2a-3f7a074bd3a4-bg10e.png)
C
ONFIGURING
THE
S
WITCH
3-216
be assigned to hosts based on the client identifier code or MAC address.
Command Usage
• First configure any excluded addresses, including the address for this
switch.
• Then configure address pools for the network interfaces. You can
configure up to 8 network address pools. You can also manually bind
an address to a specific client if required. However, any fixed addresses
must fall within the range of an existing network address pool. You can
configure up to 32 fixed host addresses (i.e., entering one address per
pool).
Enabling the Server, Setting Excluded Addresses
Enable the DHCP Server and specify the IP addresses that it should not
be assigned to clients.
Command Attributes
• DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
• Excluded Addresses – Specifies IP addresses that the DHCP server
should not assign to DHCP clients. You can specify a single address or
an address range.
Note: Be sure you exclude the address for this switch and other key
network devices.
8 network
address pools
Address
Pool
Static
Addresses
32 static addresses
(all within the confines
of configured network
address pools)