Filter
Top Products
S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-47
known hosts file on the management station and place the host public
key in it. An entry for a public key in the known hosts file would
appear similar to the following example:
10.1.0.54 1024 35 15684995401867669259333946775054617325313674890836547254
15020245593199868544358361651999923329781766065830956 10825913212890233
76546801726272571413428762941301196195566782 59566410486957427888146206
51941746772984865468615717739390164779355942303577413098022737087794545240839
71752646358058176716709574804776117
3. Import Client’s Public Key to the Switch – Use the copy tftp
public-key command to copy a file containing the public key for all
the SSH client’s granted management access to the switch. The clients
are subsequently authenticated using these keys. The current firmware
only accepts public key files based on standard UNIX format as
shown in the following example:
1024 35 1341081685609893921040944920155425347631641921872958921143173880
05553616163105177594083868631109291232226828519254374603100937187721199696317
81366277414168985132049117204830339254324101637997592371449011938006090253948
40848271781943722884025331159521348610229029789827213532671316294325328189150
45306393916643 steve@192.168.1.19
4. Set the Optional Parameters – Set other optional parameters, including
the authentication timeout, the number of retries, and the server key
size.
5. Enable SSH Service – Use the ip ssh server command to enable the
SSH server on the switch.
6. Configure Challenge-Response Authentication – When an SSH client
attempts to contact the switch, the SSH server uses the host key pair
to negotiate a session key and encryption method. Only clients that
have a private key corresponding to the public keys stored on the
switch can gain access. The following exchanges take place during this
process:
a. The client sends its public key to the switch.
b. The switch compares the client's public key to those stored in memory.