SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
-212
Virtual Router Redundancy Protocol Commands
To configure VRRP, select an interface on one router in the group to serve
as the master virtual router. This physical interface is used as the virtual
address for the router group. Now set the same virtual address and a
priority on the backup routers, and configure an authentication string. You
can also enable the preempt feature which allows a router to take over as
the master router when it comes on line.
vrrp ip
Use this command to enable the Virtual Router Redundancy Protocol
(VRRP) on an interface and specify the IP address of the virtual router.
Command Function Mode Page
vrrp ip Enables VRRP and sets the IP address of the
virtual router
IC 3-212
vrrp authentication key Configures a key used to authenticate VRRP
packets received from other routers
IC 3-214
vrrp priority Sets the priority of this router in the VRRP group IC 3-215
vrrp timers advertise Sets the interval between successive
advertisements by the master virtual router
IC 3-216
vrrp preempt Configures the router to take over as master
virtual router for a VRRP group if it has a higher
priority than the current master virtual router
IC 3-217
show vrrp Displays VRRP status information PE 3-218
show vrrp interface Displays VRRP status information for the
specified interface
PE 3-220
show vrrp router
counters
Displays VRRP statistics PE 3-222
show vrrp interface
counters
Displays VRRP statistics for the specified
interface
PE 3-222
clear vrrp router
counters
Clears VRRP router statistics PE 3-223
clear vrrp interface
counters
Clears VRRP interface statistics PE 3-223