SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
-118
Anything outside this format will not be accepted by the configuration
program.
An interface can have only one primary IP address, but can have many
secondary IP addresses. In other words, you will need to specify
secondary addresses if more than one IP subnet can be accessed via this
interface.
If you select the bootp or dhcp option, IP is enabled but will not
function until a BOOTP or DHCP reply has been received. Requests
will be broadcast periodically by this device in an effort to learn its IP
address. (BOOTP and DHCP values can include the IP address,
default gateway, and subnet mask).
You can start broadcasting BOOTP or DHCP requests by entering an
ip dhcp restart client command, or by rebooting the router.
Notes:1.Each VLAN group can be assigned its own IP interface address.
Therefore, if routing is enabled, you can manage the router via
any of these IP addresses.
2. Before you can change the primary IP address on an interface, you
must first clear the current address with the no form of this command.
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart client (3-156)
ip default-gateway
This command establishes a static route between this router and devices
that exist on another network segment. Use the no form to remove the
static route.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#