SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
M
ULTICAST
R
OUTING
C
OMMANDS
-191
DVMRP Multicast Routing Commands
router dvmrp
Use this command to enable Distance-Vector Multicast Routing (DVMRP)
globally for the router and to enter router configuration mode. Use the no
form to disable DVMRP multicast routing.
Command Function Mode Page
router dvmrp Enables DVMRP and enters router
configuration mode
GC 3-191
probe-interval Sets the interval for sending neighbor probe
messages
RC 3-192
nbr-timeout Sets the delay before declaring an attached
neighbor router down
RC 3-193
report-interval Sets the interval for propagating the complete set
of routing tables to other neighbor routers
RC 3-194
flash-update-interval Sets the interval for sending updates about
changes to network topology
RC 3-194
prune-lifetime Defines how long a prune state remains in effect
for a source-routed multicast tree
RC 3-195
default-gateway Configures the default gateway for IP multicast
routing
RC 3-196
ip dvmrp Enables DVMRP on the specified interface IC 3-197
ip dvmrp metric Sets the metric used when establishing reverse
paths to some networks on directly attached
interfaces
IC 3-198
clear ip dvmrp route Clears all dynamic routes in the multicast routing
table
PE 3-198
show router dvmrp Displays global DVMRP configuration settings NE,
PE
3-199
show ip dvmrp route Displays DVMRP routing information NE,
PE
3-200
show ip dvmrp
neighbor
Displays DVMRP neighbor information NE,
PE
3-201
show ip dvmrp
interface
Displays DVMRP configuration settings for the
interfaces
NE,
PE
3-202