SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
-230
standby authentication
Use this command to specify the key used to authenticate HSRP packets
received from other routers. Use the no form to delete an authentication
string.
Syntax
standby [group] authentication string
no standby [group] authentication
group - Identifies the HSRP group. (Range: 0-255)
string - Authentication string. (Range: 1-8 alphanumeric characters)
Default Setting
Group number: 0
String: not defined
Command Mode
Interface (VLAN)
Command Usage
All routers in the same HSRP group must be configured with the same
authentication string. The authentication string is sent unencrypted in
all HSRP messages.
When an HSRP packet is received from another router in the group, its
authentication string is compared to the string configured on this
router. If the strings match, the message is accepted. Otherwise, the
packet is discarded. If the authentication strings do not match, this
router will not be able to learn the designated address for the group and
timer values from other routers. However, even if authentication fails,
this cannot prevent a router from taking over as the master router if it
has the highest priority in the group.
Priority takes precedence over authentication. In other words, if a
router is configured with the standby priority command to have the
highest priority in the group, but does not have an authentication
string, or is configured with the wrong string, it will still take over as the
active master.