SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
L
INE
C
OMMANDS
4-15
The access mode shown in the following tables is indicated by these
abbreviations:
NE (Normal Exec) VC (VLAN Database Configuration)
PE (Privileged Exec) MST (Multiple Spanning Tree)
GC (Global Configuration) ACL (Access Control List Configuration)
LC (Line Configuration) DC (DHCP Server Configuration)
IC (Interface Configuration) RC (Router Configuration)
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
Command Function Mode Page
line Identifies a specific line for configuration and starts the
line configuration mode
GC 3-16
login Enables password checking at login LC 3-17
password Specifies a password on a line LC 3-18
exec-timeout Sets the interval that the command interpreter waits
until user input is detected
LC 3-19
password-thresh Sets the password intrusion threshold, which limits the
number of failed logon attempts
LC 3-20
silent-time* Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
password-thresh command
LC 3-21
databits* Sets the number of data bits per character that are
interpreted and generated by hardware
LC 3-22
parity* Defines the generation of a parity bit LC 3-23
speed* Sets the terminal baud rate LC 3-24
stopbits* Sets the number of the stop bits transmitted per byte LC 3-24
* These commands only apply to the serial port.