SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
C
ONFIGURING
THE
S
WITCH
3-274
There are several serious problems with RIP that you should consider.
First of all, RIP (version 1) has no knowledge of subnets, both RIP
versions can take a long time to converge on a new route after the
failure of a link or router during which time routing loops may occur,
and its small hop count limitation of 15 restricts its use to smaller
networks. Moreover, RIP (version 1) wastes valuable network
bandwidth by propagating routing information via broadcasts; it also
considers too few network variables to make the best routing decision.
Configuring General Protocol Settings
RIP is used to specify how routers exchange routing information. When
RIP is enabled on this router, it sends RIP messages to all devices in the
network every 30 seconds (by default), and updates its own routing table
when RIP messages are received from other routers. To communicate
properly with other routers using RIP, you need to specify the RIP version
used globally by the router, as well as the RIP send and receive versions
used on specific interfaces (page 3-277).
Command Usage
When you specify a Global RIP Version, any VLAN interface not
previously set to a specific Receive or Send Version (page 3-277) is set
to the following values:
- RIP Version 1 configures previously unset interfaces to send
RIPv1 compatible protocol messages and receive either RIPv1 or
RIPv2 protocol messages.
- RIP Version 2 configures previously unset interfaces to use RIPv2
for both sending and receiving protocol messages.
•The update timer is the fundamental timer used to control all basic RIP
processes.
- Setting the update timer to a short interval can cause the router to
spend an excessive amount of time processing updates. On the
other hand, setting it to an excessively long time will make the
routing protocol less sensitive to changes in the network
configuration.