SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
-66
To configure protocol-based VLANs, follow these steps:
1. First configure VLAN groups for the protocols you want to use
(page 3-55). Although not mandatory, we suggest configuring a
separate VLAN for each major protocol running on your network.
Do not add port members at this time.
2. Create a protocol group for each of the protocols you want to assign
to a VLAN using the protocol-vlan protocol-group command
(General Configuration mode).
3. Then map the protocol for each interface to the appropriate VLAN
using the protocol-vlan protocol-group command (Interface
Configuration mode).
protocol-vlan protocol-group (Configuring Groups)
This command creates a protocol group, or to add specific protocols to a
group. Use the no form to remove a protocol group.
Syntax
protocol-vlan protocol-group group-id [{add | remove} frame-type
frame protocol-type protocol]
no protocol-vlan protocol-group group-id
group-id - Group identifier of this protocol group. (Range:
1-2147483647)
frame - Frame type used by this protocol. (Options: ethernet,
rfc_1042, snap_8021h, snap_other, llc_other)
protocol - Protocol type. The only option for the llc_other frame type
is ipx_raw. The options for all other frames types include: ip, arp,
show protocol-vlan
protocol-group
Shows the configuration of protocol groups PE 3-68
show interfaces
protocol-vlan
protocol-group
Shows the interfaces mapped to a protocol
group and the corresponding VLAN
PE 3-69
Command Function Mode Page