SMC Networks SMC8612XL3 F 1.0.1.3 Switch User Manual


 
-226
form to disable HSRP on an interface and remove the IP address for the
virtual router.
Syntax
standby [group] ip [ip-address [secondary]]
no standby [group] ip [ip-address]
group - Identifies the virtual router group. (Range: 0-255)
ip-address - The designated IP address of the virtual router.
secondary - Specifies additional IP addresses supported by this
group.
Default Setting
Group number: 0
Virtual router groups: none configured
Command Mode
Interface (VLAN)
Command Usage
The designated IP address must be configured on at least one router in
the virtual router group. If an IP address is specified in this command,
that address is used as the designated address for the virtual group. If
an IP address is not specified, the designated address is learned through
the exchange of HSRP messages. Note that the designated address
cannot be the same as a physical address.
The subnet mask for the physical interface on which the designated
address is configured is used as the subnet mask of the designated
address. The interfaces of all routers participating in a virtual router
group must be within the same IP subnet.
Configuring a new designated address on the current master router will
override the designated address currently is use.
If you have multiple secondary addresses configured on the current
VLAN interface, you can use this command with the secondary
keyword to add any secondary address that will be supported by the
virtual router.