Sun Microsystems SL8500 Computer Drive User Manual


 
Automated Mode of Operation
46 StreamLine™ SL8500 Modular Library System User's Guide March 2007 Revision K 96154
4. The host command is translated by the library controller into motion commands for
the robot.
5. The cartridge is taken from its slot and placed in the drive.
6. The library returns status to the host that the mount operation is completed.
7. The drive then performs the read/write activity directed by the host.
Dismount Sequence
A simplified dismount sequence involves the following steps:
1. A host requests that a specific VOLID be dismounted from a drive.
2. The library transmits to the host that the VOLID is located in the drive and the
library is available to satisfy the dismount request.
3. The library assumes responsibility for the dismount.
4. The host command is translated by the library controller into mechanical commands
for the robot.
5. The cartridge is taken from the drive and placed into its home slot.
6. The library returns status to the host that the dismount operation is completed.
The library then awaits another activity directed by the host or continues those
activities waiting in the library’s queue of commands.
Performing CAP Activities
Note – This section describes general CAP activities applying to all libraries. For
specific information on CAP activities in partitioned libraries, see “Using CAPS in a
Partitioned Library” on page 53.
The CAP door contains a standard CAP A (on the left, as viewed from the front); an
additional CAP (CAP B, on the right) is also available. CAPs allow you to import
(enter) cartridges and export (eject) cartridges from the library.
A single CAP contains three magazines; each magazine contains 13 cells, allowing
import/export of up to 39 cartridges at a time. The magazines can be removed from the
CAP to import cartridges in a batch mode. Rotation of the CAP is accomplished
through a motor. CAP operations are controlled by the HBZ logic card.
The CAP magazines span the lower three rails and on the right side of the library only.
To import or export a cartridge from the top rail on the right side, a HandBot places the
cartridge in an elevator slot to accomplish the move.