Filter
Top Products
Answer y if you plan to incorporate the single node cluster into a multi-node
cluster in the future.
Continue with the installation.
See “Licensing VCS” on page 63.
Creating a single-node cluster manually
Table 8-2 specifies the tasks that you need to perform to install VCS on a single
node.
Table 8-2
Tasks to create a single-node cluster manually
ReferenceTask
See “Setting the path variable for a
manual single node installation”
on page 141.
Set the PATH variable
See “Installing the VCS software
manuallyonasinglenode”on page141.
Install the VCS software manually and add a
license key
See “Renaming the LLT and GAB
startup files” on page 142.
Remove any LLT or GAB configuration files and
rename LLT and GAB startup files.
A single-node cluster does not require the
node-to-nodecommunicationservice,LLT,orthe
membership communication service, GAB.
See “Modifying the startup files”
on page 142.
Modify the VCS startup file for single-node
operation.
Create and modify the VCS configuration files.
See “Verifying single-node operation”
on page 142.
Start VCS and verify single-node operation.
Setting the path variable for a manual single node installation
Set the path variable.
See “Setting the PATH variable” on page 47.
Installing the VCS software manually on a single node
Install the VCS 5.0 RU3 RPMs manually and install the license key.
Refer to the following sections:
141Installing VCS on a single node
Creating a single-node cluster manually