Filter
Top Products
Getting Started
K1297-G20 Monitor User Manual
33
Installing Modules
CAUTION. Make sure the VME bus address on the new module is set
correctly (see page 30).
If you install modules, proceed as follows:
1. Switch the device off and unplug the mains plug.
2. Remove the cover if necessary and put the module on the guide rails of
the relevant slot.
3. Push the module completely into the slot.
4. Tighten the module with the two cross-head screws.
NOTE. If you have to install a new E1/DS1 board and/or an AP-4 board,
the Protocol Tester reprograms the boot Flash-PROM of this new board.
Reprogramming is done automatically during the start-up sequence of the
application and takes much more time than the normal start-up sequence.
Therefore just be patient. You must not switch off or shut down the
Protocol Tester during this time.
The reprogramming is finished as soon as the LEDs of the new boards are
off and the Protocol Tester shows the Data Flow Window. Although the
tester is then ready to work, you have to close all K1297-G20 Monitor
applications and start them (only the applications, not Windows XPe)
again.