Filter
Top Products
Getting Started
36
K1297-G20 Monitor User Manual
Switching on the Device
Make sure that the keyboard cable is connected to the keyboard interface,
the mains cable is supplied to the non-heating appliance socket and the
mains plug is plugged into a socket with protective ground.
1. Switch the device on using the ON/OFF switch (see page 13).
2. The Protocol Tester is set ready-to-run upon delivery. The device
automatically boots after switching on. The operating system is loaded
and the application is then started automatically.
If you start Windows XPe for the first time, you are automatically
logged on as administrator with the following information:
User name: Administrator-K12
Password: xinortket12k
CAUTION. Do not change the pre-configured Administrator-K12 account,
since password changes also require modifications of the automatic logon.
For those changes, precise knowledge about the concept of user accounts
and user groups in Windows XP is required. The risk of changes which the
customer undertakes is carried by the customer.
Reprogramming of Flash-PROMs. During the first start after installation the
Flash-PROM of your interface boards may be reprogrammed. This may
take some time. Do not switch off the Protocol Tester during the
reprogramming process.
After reprogramming is completed you may have to close and restart the
K1297-G20 Monitor application. Depending on the type and number of
interface cards this procedure might have to be repeated once for each
interface card.