Filter
Top Products
Getting Started
48
K1297-G20 Monitor User Manual
5. In the product selection dialog box, installed software packages are
indicated by their version numbers in the column State.
DO NOT deselect any installed products.
Check that all additional software packages that shall be installed are
selected. Their selection might fail if:
a. an incorrect or incomplete keyfile was selected before or
b. not all necessary software packages were purchased or installed.
In case a. choose the correct keyfile using the button that indicates the
currently used keyfile.
In case b. install all software packages that you have purchased for this
system. Therefore, you might need to access all keyfiles you have
received in all deliveries for this software version for this system. If
you cannot proceed, contact the technical support.
6. Press Next to test your selection against the provided keys.
NOTE. The Next button may be disabled. One possible reason is that
not enough space is available on the hard disk. In that case, try to save
space until the setup program displays at least 20 % free disk space.
7. Press Start when the key check finished successfully.
CAUTION. Do not interrupt the installation program once you have clicked
Start. If the program is inadvertently interrupted, rename the file
C:\WINDOWS\UNINSTALL.K12XX.INI.0x with the highest number
for x to C:\WINDOWS\UNINSTALL.K12XX.INI.
Start the installation program again.
8. After the installation is complete, remove the key disk from the floppy
disk drive and reboot your Protocol Tester.