Filter
Top Products
Getting Started
58
K1297-G20 Monitor User Manual
Ethernet Connection
If you want to operate the protocol tester in a local Ethernet network, you
can use the built-in network adapter of the protocol tester. To establish an
Ethernet connection, connect your Ethernet cable to the 10BaseT /
100BaseTX connector of the K1297 PC board.
The properties for the default connection can you see in the Local Area
Connection Properties dialog box. To open this dialog box, proceed as follows:
1. Select Start / Control Panel / Network Connections. The Network
Connections dialog box opens.
2. Double-click an active Local Area Connection. A Status dialog box for
this connection opens. By pressing the Properties button you open the
Local Area Connection Properties dialog box.
Figure 1: Local Area Connection Properties, Generals tab