Filter
Top Products
Getting Started
K1297-G20 Monitor User Manual
51
Installing the Software. To install a new software version, proceed as
follows:
1. Close all applications.
2. Connect the optional external CD drive directly to your Protocol Tester
or create an access to a network CD drive.
If you install the software from a CD network drive, do not browse the
network neighborhood to access this location. Map the share
containing the CD to an unused drive letter instead, such as ”E:”
or ”F:”
3. Insert the key disk into the floppy disk drive of the Protocol Tester. The
key disk contains a serial number, which must be the same as the
nameplate fabrication code (Ser.-No.) on the back of the device.
4. Insert the installation CD into the CD drive. The Setup Guide starts
automatically. The Setup Guide helps you to successfully install your
Protocol Tester software. Follow the Setup Guide instructions.
If the installation does not start automatically, double-click
RunIntro.bat from the root directory of the CD.
Follow the setup program instructions. Read carefully the enclosed
license agreement and respond to the prompts.
Specify a valid keyfile within the keyfile selection dialog box, if you
do not want to use the keyfile.txt of the key disk in the floppy
disk drive.
In the subsequent dialog boxes, click Next.
NOTE. The Setup program warns you, if products cannot be installed on
your system because of missing destination drives. The affected products
(such as Conformance Tests which require a D: disk drive) are reported in
a warning dialog box; they will NOT be listed in the ”List of Available
Products” of the Setup program.
If such a warning appears, proceed as described on page 46.