Filter
Top Products
For an adjustmentto make the Print Headparallel to the Platen Roller,continue as follows:
Step 8. Unlatch and raise the Print Head.
Step 9. Slightly loosen the Print Head fasteners shown in Figure 6-9. However, try to
maintain a tightness just sufficient to leave the Print Head position undisturbed.
Step 10. Examine the last Test Card printed to determine which side has a reduced
brightness. Then, slightly lower the corresponding side of the Print Head, and
tighten the screws.
Step 11. Perform a Peel Bar adjustment (see Section 6.3.4).
Step 12. Latch down the Print Head, and print another Test Card, Note the result of
the repositioning.
Step 13. Repeate Steps eight through 12 until a proper result is achieved.
980264-001 Rev. B 6-11
CHAPTER 6
Figure 6-9. Lower Print Head Fasteners.