Filter
Top Products
5.2.5 Card Feeder Part Removals
Figure 5-5 shows the fasteners associated with Card Feeder parts. Replaceable items
include the Belt, Roller, Motor, or the unit as a whole.
To replace the Belt, slide on a new belt in place of the old.
To replace the Motor, remove belt and the three screws holding the motor, and unplug
the motor connector from the Daughter Board.
To replace the Roller, first remove the whole unit. Then, using a small flat tipped
screwdriver, pry to release the snap-in tabs holding each end of the Roller Assembly. Drop
in a new Roller in place of the old, and return the tabs to their associated slots.
To replace the unit as a whole, remove the two screws and disconnect the spade lug
that grounds the anti-static brush. Unplug the motor connector as described for Motor
Replacement.
980264-001 Rev. B 5-7
CHAPTER 5
Figure 5-5. Card Feeder Rear