Filter
Top Products
5.2.19 Ribbon Take Up Spindle Replacements
Figure 5-31 shows the Ribbon Take Up Spindle. Replacement options include any of the parts
that appear in the exploded view.
Step 1. Remove the Rear Case (see Section 5.2.1) the Front Case (see Section 5.2.2)
and the Rear Plate (see Section 5.2.3).
Step 2. Remove the o-ring belt from the Spindle Pulley.
Step 3. Remove the screw and captive washer holding the Take Up Spindle, and slide
the spindle off of the rod.
Step 4. To replace any parts still attached to the rod, slide the assembly toward the
rear until free of the printer.
5-32 980264-001 Rev.B
CHAPTER 5