Filter
Top Products
5.2.11 Rear Plate Removal
Access to the Daughter Board and the associated motor and sensor connectors, and their
related component replacements, requires removal of the Rear Plate. Of these, only the
Card Feed Motor Connector is accessible with the Rear Plate in place. Refer to Figure
5-15, and proceed as follows:
Step 1. Remove the Rear Case member (see Section 5.2.1).
Step 2. Unplug the connectors attached to the circuit boards (see Section 5.2.10).
Step 3. Remove the three screws holding the Rear Plate, followed by the plate itself.
Note that the figure shows the Rear Plate without the circuit boards, which can
remain attached.
Step 4. Remove the Cam Follower Rod and Flywheel when required for access to
underlying components. Note rotations for Cam Follower Rod attachment points.
980264-001 Rev. B 5-17
CHAPTER 5
Figure 5-15. Rear Plate Removals.