Filter
Top Products
5.2.7 Fan Removal
Two self-tapping screws secure both the Fan and the associated Fan Guard. Refer to
Figure 5-11, and proceed as follows:
Step 1. Remove the Rear Case Member (see Section 5.2.2).
Step 2. Disconnect the Fan Connector from the CPU Board.
Step 3. Remove the two self-tapping screws holding the Fan and Fan Guard.
Step 5. Open the Print Head and, while feeding the Fan Wires, pull the Fan and Fan
Guard out through the front side of the Print Head Assembly.
980264-001 Rev. B 5-13
CHAPTER 5
Figure 5-11. Fan Replacement