Filter
Top Products
2.2.5 Card Gate Adjustment
Figure 2-14 shows the Card Gate Adjustment Lever with arrows that show the directions
of travel.
Step 1. Set the Card Gate Thickness Lever to match the thickness of the cards. Note
that lever positions closer to the back of the printer open the Card Feed Gate for
thicker cards.
Step 2. If during operation cards either fail to feed or multiple card feeds occur, check
the setting of the Card Gate Adjustment Lever. Increase the opening if cards fail to
feed, and decrease the opening if too many cards feed at the same time. Also,
avoid using warped cards. Warped cards can require Card Gate openings greater
than the one indicated for the card size loaded.
2-12 980264-001 Rev.B
CHAPTER 2
Figure 2-14. Card Gate Adjustment