Filter
Top Products
DocuTech 128/155/180 HighLight Color Operator Guide 3-59
Routine maintenance
12. Slowly and carefully pull about 3 feet (1 meter) of wire from the
spool.
13. Cut the wire, leaving about 2 inches (51mm) of wire extending
from the end of the stitcher plug.
14. Insert the plug into the measuring bracket.
15. Continue to feed the wire until it touches the back plate of the
measuring bracket.
16. Push the green stitcher head release handle down and back.
17. Pull the plug from the measuring bracket.
18. Insert the plug into the stitcher head until the plug snaps into
place.
19. Place the wire cutters in the storage bracket.
NOTE: Ensure that the wire cutters are not touching the
stitcher spools. This can prevent the stitcher wire from feeding
properly.
20. Lower the stitcher panel.
NOTE: Ensure that the stitcher panel has been lowered. The
stacker will not deliver prints if the stitcher panel is left in the up
position.
21. Close the finisher doors.
Storing the binder tape reels
NOTE: Production publisher configuration only
Binder tape contains paper that makes the tape sensitive to the
same conditions that affect paper, especially moisture. Figure 3-60
shows good storage conditions for the binder tape.