Filter
Top Products
DocuTech 128/155/180 HighLight Color Operator Guide 3-61
Routine maintenance
Replacing the binder tape reel
NOTE: Production publisher configuration only
Use this procedure to replace the binder tape in the system.
To ensure proper binding and to reduce binder tape jams, do not
leave binder tape in the system when the binder is not in use.
If necessary, refer to the label on the binder for instructions on how
to replace the binder tape.
The following steps must be performed to replace the binder tape
wheel.
WARNING: All areas of the binder drawer, including the binder
tape, are hot, approximately 425°F (218°C), and may cause
serious burns. If the binder has been in a "Ready" condition, allow
the binder drawer to cool at least one hour before continuing the
procedure.
1. Open the finisher doors.
2. Grasp the green handle on the binder drawer and pull the
drawer out until it stops.
Figure 3-62 Opening the binder drawer
3. Remove the tape from the drive roll.
a. Lift the pressure roll release handle and remove the tape
from the drive roll.