Filter
Top Products
3-12 DocuTech 128/155/180 HighLight Color Operator Guide
Routine maintenance
Maintaining the printer
A screen message is displayed when it is necessary to replace
system supplies. To ensure that the system runs efficiently,
replace the supplies as soon as possible.
Replacing the black dry ink bottle
When directed by a screen message, replace the black dry ink
bottle. If the bottle is not replaced, the printer will eventually stop,
and it will not operate until a new bottle is installed.
CAUTION: To prevent dry ink spills, remove the bottle only when
directed to do so by a message on the screen.
CAUTION: Do not use warm or hot water, or general cleaning
solvents to remove dry ink from your skin or clothing. The heat or
solvent will set the dry ink and make it difficult to remove.
CAUTION: If any dry ink should get on your clothes, brushing
with a dry paper towel or a stiff-bristled brush may remove the ink.
If not, launder your clothes with detergent and cold water. Tell a
commercial dry cleaner that the spot is dry ink or "toner" so that
they will not use a solvent that will set the dry ink stain.
Replace the black dry ink bottle
The following steps must be performed to replace the black dry ink
bottle.
1. Open the front processor access door and locate the black dry
ink bottle at the left side of the processor.
2. Place a drop cloth on the floor under the dry ink bottle area.
3. Remove the empty bottle by grasping the bottle handle. With a
slow, firm motion, pull the bottle from the bottle guide.
a. Pull the empty dry ink bottle out until it stops.
b. Move the green handle to the unlatched position.
c. Remove the empty bottle and discard it.