Filter
Top Products
DocuTech 128/155/180 HighLight Color Operator Guide 5-7
Technical information
Table 5-4. Satisfaction guide for 2-sided printing
Using various stocks
The following table lists stock that have been evaluated and tested
for use in this system. There are many other stocks available,
some of which may not provide the same degree of user
satisfaction. Refer to the “Using non-standard stock” section in this
guide
Type or
condition
Xerographic bond
paper in good
condition
Drilled stock, fanned
thoroughly
Slightly curled paper
Intermixed weights
Xerox vellum
Full cut tabs
Label stock
Adhesive drafting film
Paper with reinforced edges
Do not use excessively curled
paper
Substance 110 (200 g/m2) must
be long grain. Do not use short
grain.
Precut tabs - use tray 1 or 2.
Transparencies with a white
stripe, use tray 1 or 2.
Freshly printed offset prints, use
tray 3.
Refer to the “Using various
stocks” section for any stock not
defined in this guide.
Stock
Reliable feeds may
be expected
Less reliable feeds may be
expected
Suggested alternatives
Stock
Reliable feeds may
be expected
Less reliable feeds may be
expected
Suggested alternatives
Size 8 x 10 inches to 17 x
11 inches (203 x 254
mm to 432 x 279 mm)
17 x 11 inch (432 x 279 mm)
paper can only be sent to the top
tray.
Weight Substance 16 to 110
(60 to 200 g/m2)
Substance 110 (200
g/m2) must be long
grain.
Weights outside the limits shown
are not recommended.
Type or
condition
Xerographic bond
paper in good
condition
Drilled stock, fanned
thoroughly
Slightly curled paper
Paper with reinforced edges
Do not use excessively curled
paper.
Refer to the “Using various
stocks” section for any stock not
defined in this guide.