Filter
Top Products
30 Zebra 105SL User’s Guide
3HHO2II0RGH
NOTE: The following instructions pertain to printers with the
rewind option only.
Refer to Figure 17.
1. Remove the rewind plate from the front of the printer (if installed).
Store it upside down on the two mounting screws on the inside of the
front panel.
2. Open the printhead.
3. Slide the media guide and media supply guide as far from the printer
frame as possible.
4. Load media as shown.
5. When loading media, allow approximately 36" (915 mm) of media to
extend past the tear-off/peel-off bar. Remove all labels from this
portion to create a leader.
6. Remove the hook from the rewind spindle. If you are using a core,
slide it onto the rewind spindle until it is flush against the guide plate.
7. Wind the label backing around either the 3" (76.2 mm) core or the
rewind spindle and reinstall the hook.
8. Slide in the media guide and media supply guide so they just touch,
but don’t restrict, the edge of the roll.
Before closing the printhead, make sure:
• The media is positioned against the inside guides.
• The media is taut and parallel with itself and the pathway when wound
onto the rewind spindle/core.
9. Close the printhead.
10. To discard the label backing from the rewind spindle, refer to
“Removing the Label Backing Material” on page 37.