Zebra Technologies 105SL Printer User Manual


 
48 Zebra 105SL User’s Guide
Press Display Shows Action/Explanation
PRINT WIDTH
Setting Print Width: Press the (+) key to increase the value,
press the (–) key to toggle to a different digit. To change the unit
of measurement, press the (–) key until the unit of measurement
is active, then press the (+) key to toggle to a different unit of
measure (inches, mm, or dots).
Default; Range: The default and range of acceptable values
vary depending on what printer you have. Refer to “Printing
Specifications” on page 94 for further information about the
ranges available for your model.
Print width determines the printable area across the width of the
label.
MAXIMUM LENGTH
Setting Maximum Length: Press the (–) key to decrease the
value, press the (+) key to increase the value.
Default; Range: The default and range of acceptable values
vary depending on your printer’s configuration. Values are
adjustable in 1” (25.4 mm) increments.
Maximum length is used in conjunction with the calibration
procedure. The value of this setting determines the maximum
label length used during the media portion of the calibration
process. Only a few labels are required to set media sensors.
Always set the value that is closest to, but not lower than, the
length of the label you are using. For example, if the length of the
label is 14.5 inches (368 mm), set the parameter for 15.0 inches
(381 mm).