Zebra Technologies 105SL Printer User Manual


 
32 Zebra 105SL User’s Guide
5HZLQG0RGH
(Rewind option required)
Refer to Figure 18.
1. Remove the rewind plate from its storage location in front of the print
mechanism inside the media compartment.
2. Invert the rewind plate so that the lip on the attached hook plate points
down.
3. Insert the hook plate lip a short distance (½" or 13 mm) into the lower
opening in the side plate.
4. Align the upper end of the rewind plate with the corresponding
opening in the side plate. Slide in the rewind plate so that it stops
against the printer’s main frame.
5. Open the printhead.
6. Slide the media guide and media supply guide as far from the printer
frame as possible.
7. Load media as shown.
8. When loading media, allow approximately 36" (915 mm) of media to
extend past the printhead. Remove all labels from this portion to
create a leader.
9. Remove the hook from the rewind spindle. If you are using a core,
slide it onto the rewind spindle until it is flush against the guide plate.
10. Wind the label backing around either the 3" (76.2 mm) core or the
rewind spindle and reinstall the hook.
11. Slide in the media guide and media supply guide so they just touch,
but don’t restrict, the edge of the roll.