Filter
Top Products
82 Zebra 105SL User’s Guide
3ULQW4XDOLW\3UREOHPV
*HQHUDO3ULQW4XDOLW\,VVXHV
*UD\OLQHVRQEODQNODEHOVZLWKQRFRQVLVWHQWSDWWHUQ
/LJKWFRQVLVWHQWYHUWLFDOOLQHVUXQQLQJWKURXJKDOORIWKHODEHOV
,QWHUPLWWHQWFUHDVHVRQWKHOHIWDQGULJKWHGJHVRIWKHODEHOV
Problem Solution
You are using an incorrect media and ribbon
combination for your application.
Consult your authorized Zebra reseller/distributor for
information and advice.
The printer is set at the incorrect print
speed.
For optimal print quality, set the print speed to the lowest
possible setting via ZPL II, the driver, or the software.
The printer is set at the incorrect darkness
level.
For optimal print quality, set the darkness to the lowest
possible setting via the front panel, the driver, or the
software.
The printhead is dirty. Clean the printhead according to the instructions on
page 66.
There is light printing (or no printing) on the
left or right side of the label or the printed
image is not sharp.
The toggle pressure needs to be adjusted. Follow the
printhead pressure adjustment instructions on page 77.
Problem Solution
The printhead is dirty. Clean the printhead according to the instructions on
page 66.
Problem Solution
The printhead or platen roller is dirty. Clean the printhead, platen roller, or both according to the
instructions on page 66.
Problem Solution
There is too much toggle pressure on the
printhead.
Reduce the toggle pressure. See “Printhead Pressure
Adjustment” on page 77.