Filter
Top Products
62 Zebra 105SL User’s Guide
* ZebraNet
®
PrintServer II option required
Press Display
Shows
Action/Explanation
IP RESOLUTION*
IP Resolution: Press the (+) or (–) key to display other choices.
Default: Dynamic
Selections: Dynamic, permanent
Depending on the selection, allows either the user (”permanent”) or
the server (”dynamic”) to select the IP address. For more
information, refer to ZebraNet Networking: PrintServer II Installation
and User’s Guide.
IP PROTOCOLS*
IP Protocols: Press the (+) or (–) key to display other choices.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP,
DHCP/BOOTP
If “dynamic” was chosen in the previous parameter, this selection
determines the method(s) by which the PrintServer II receives the
IP address from the server. For more information, refer to ZebraNet
Networking: PrintServer II Installation and User’s Guide.
IP ADDRESS*
IP Address: Press the (–) key to move to the next digit position,
press the (+) key to increase the value of the digit.
This parameter allows you to select the IP address if “permanent”
was chosen in “IP RESOLUTION.” (If “dynamic” was chosen, the
user cannot select the address.) For more information, refer to
ZebraNet Networking: PrintServer II Installation and User’s Guide.
SUBNET MASK*
Subnet Mask: Press the (+) or (–) key to display other choices.
Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign),
permanent
This parameter selects the part of the IP address that is considered
to be part of the local network. It can be reached without going
through the default gateway.
DEFAULT
GATEWAY*
Default Gateway: Press the (–) key to move to the next digit
position, press the (+) key to increase the value of the digit.
This parameter allows you to select the IP address that the network
traffic is routed through if the destination address is not part of the
local network.