Filter
Top Products
Zebra 105SL User’s Guide 51
INIT FLASH MEM
Initialize Flash Memory
CAUTION: Perform this operation only when it is necessary to
erase all previously stored information from the
FLASH memory. Press the NEXT/SAVE key to
bypass this function.
1. Press the (+) key to select “YES.”
If your printer is set to require a password, you are
prompted to enter the password. Enter the password and
then press the NEXT/SAVE key.
2. The display asks “INITIALIZE FLASH?”. Press the (+) key to
select “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the (+) key “YES” to begin initialization.
or
Press the (–) key “NO” to cancel the request and return to the
“INITIALIZE FLASH” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display flashes
back and forth between the two phrases “CHECKING E:
MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer automatically exits
the configuration mode and the front panel displays “PRINTER
READY.”
NOTE: Depending on the amount of free FLASH memory,
initialization may take up to one minute to complete.