Filter
Top Products
Zebra 105SL User’s Guide 111
®®lcàÍ_ÍÍ-"ÍAÃc
3&0&,$&DUG,QVWDOODWLRQ
The PCMCIA card slot is a factory-installed option. If your printer has
this option, you may install or change the card at any time. Use the
following procedure to install a PCMCIA card.
CAUTION: Observe proper electrostatic safety precautions
when handling any static-sensitive components such as printed
circuit boards and printheads.
1. Turn the AC power switch in the Off (2) position and disconnect the
AC power cord. Disconnect the data cables.
2. Refer to Figure 47. Remove and retain the screw and the option card
shield from the rear of the printer.
3. If you are replacing the card, press the card eject button and slide the
card out of the slot.
4. Slide the new card into the slot far enough that the eject button pops
out.
5. Reinstall the option card shield and secure it with the screw.
6. Reconnect the AC power cord and all data cables.
7. Press and hold the FEED key while placing the power switch in the On
(,) position.
8. Verify the presence of additional memory or optional fonts by
checking the information on the configuration label that was printed
during the power on sequence.
9. The printer is now ready to operate with the additional memory or font
option.