Filter
Top Products
96 Zebra 105SL User’s Guide
0HGLD6SHFLILFDWLRQV
* Media registration and minimum label length are affected by media type and width, ribbon type, print
speed, and printer mode of operation. Performance improves as these factors are optimized. Zebra
recommends always qualifying any application with thorough testing.
Media Specifications 105SL
Minimum label length*
Tear-off 0.7" (18 mm)
Peel-off 0.5" (13 mm)
Cutter 1.5" (38 mm)
Rewind 0.25" (6 mm)
Total media width (label + liner, if any)
Minimum 0.79" (20 mm)
Maximum 4.52" (115 mm)
Total thickness (includes liner, if any)
Minimum 0.003" (0.076 mm)
Maximum 0.012" (0.305 mm)
Cutter maximum full-width media thickness 0.009" (0.229 mm)
Roll media core inside diameter 3" (76 mm)
Maximum roll diameter 8.0" (203 mm)
Inter-label gap
Minimum 0.079" (2 mm)
Preferred 0.118" (3 mm)
Maximum
M a x i m u m i n t e r - l a b e l g a p =
2 x (label length for which you have
calibrated the printer) + 1"
M axim um inte rnal fanfo ld m edia pack size (labe l + li ner) L x W x H 8. 0" x 4. 5" x 4 .5"
(203 mm x 114 mm x 114 mm)
Ticket/tag sensing notch L x W 0.12" x 0.25" (3 mm) x (6 mm)
Ticket/tag sensing hole diameter 0.125" (3 mm)
Additional specifications for
black mark sensing
Mark length
(measuring parallel to
label/tag edge)
Minimum 0.12" (3 mm)
Maximum 0.43" (11 mm)
Mark width (measuring
to perpendicular label/
tag edge)
Minimum ≥ 0.43" (≥ 11 mm)
Maximum Full media width
Mark location Marks must be located within 0.040" (1 mm)
of the inside media edge.
Mark density >1.0 Optical Density Unit (ODU)
Maximum density of the back of the media
on which the black mark is printed 0.5 ODU