72 Zebra 105SL User’s Guide
&OHDQLQJWKH6HQVRUV
The media, ribbon, and label available sensors should be cleaned on a
regular basis to ensure proper operation of the printer. To locate these
sensors, refer to Figure 27 on page 67, Figure 6 on page 11, and Figure 7
on page 12. Brush/vacuum any accumulated paper lint and dust off of
these sensors.
&OHDQLQJWKH6QDS3ODWH
Clean the snap plate to remove label adhesive or a label that has adhered to
the underside of the snap plate.
Refer to Figure 28.
1. Insert a small-blade screwdriver or similar tool into the loop on the left
side of the snap plate. Lift the snap plate.
CAUTION: Do not
bend, twist, or otherwise deform the
loops! If the snap plate is damaged in any way, a new plate
may be required for proper ribbon sensing.
2. Repeat step one on the right side of the snap plate.
3. Remove the snap plate from the printer.
4. Clean the snap plate with cleaning solvent and a soft cloth.
Figure 28