Filter
Top Products
Zebra 105SL User’s Guide 45
/HDYLQJWKH6HWXS0RGH
You can leave the program mode at any time by pressing the SETUP/
EXIT key. The “SAVE CHANGES” display appears. There are five
choices, as described below. Pressing the (
–) or (+) key displays other
choices and pressing the NEXT/SAVE key selects the displayed choice.
• PERMANENT — Permanently saves the changes. Values are stored in
the printer even when power is turned off.
• TEMPORARY — Saves the changes until you change them again or
until power is turned off.
• CANCEL — Cancels all changes from the time you pressed the
SETUP/EXIT key except the darkness and tear-off settings (if they were
changed).
• LOAD DEFAULTS — Loads factory defaults. The factory defaults are
shown on the following pages.
NOTE: Loading factory defaults requires printer calibration.
• LOAD LAST SAVE — Loads values from the last permanent save.