Filter
Top Products
Zebra 105SL User’s Guide 35
3HHO2QO\0RGH
(Peel option required)
Refer to Figure 20.
1. Press the printhead open lever. The printhead assembly springs up.
2. Slide out the media supply guide as far from the printer frame as
possible.
3. Place the roll of media on the media supply hanger and orient the
media properly.
4. Slide in the media supply guide so that it just touches, but does not
restrict, the edge of the roll.
5. Feed the media under the inner media guide in the print mechanism.
6. Pull approximately 36" (915 mm) of media through the front of the
printer.
7. Ensure that the media is against the inner media guide. Slide in the
outer media guide so that it just touches, but does not restrict, the edge
of the media.
8. Close the printhead assembly.
NOTE: If your printer has a peel with a rewind option, remove the
rewind plate and store it upside down on the mounting screw on the
inside of the front panel before
proceeding to step #9.
9. Remove the hook from the take-up spindle shaft.
10. Remove several labels from the media backing and then wind the
backing 1-2 times around the media take-up spindle and reinstall the
hook.