Filter
Top Products
Chapter 25 Maintenance
ZyWALL 2 Plus User’s Guide
428
Figure 262 MAINTENANCE > General Setup
The following table describes the labels in this screen.
25.3 Configuring Password
Click MAINTENANCE > Password to open the following screen. Use this screen to change
the ZyWALL’s management password.
Table 160 MAINTENANCE > General Setup
LABEL DESCRIPTION
General Setup
System Name Choose a descriptive name for identification purposes. It is recommended you enter
your computer’s “Computer name” in this field. This name can be up to 30
alphanumeric characters long. Spaces are not allowed, but dashes “-” and
underscores "_" are accepted.
Domain Name The Domain Name entry is what is propagated to the DHCP clients on the LAN. If
you leave this blank, the domain name obtained by DHCP from the ISP is used.
While you must enter the host name (System Name), the domain name can be
assigned from the ZyWALL via DHCP.
Enter the domain name (if you know it) here. If you leave this field blank, the ISP
may assign a domain name via DHCP.
The domain name entered by you is given priority over the ISP assigned domain
name.
Administrator
Inactivity Timer
Type how many minutes a management session (either via the web configurator or
SMT) can be left idle before the session times out. The default is 5 minutes. After it
times out you have to log in with your password again. Very long idle timeouts may
have security risks. A value of "0" means a management session never times out,
no matter how long it has been left idle (not recommended).
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.