Filter
Top Products
Chapter 40 Firmware and Configuration File Maintenance
ZyWALL 2 Plus User’s Guide
552
40.3.3 Example of FTP Commands from the Command Line
Figure 377 FTP Session Example
40.3.4 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP
clients.
40.3.5 File Maintenance Over WAN
TFTP, FTP and Telnet over the WAN will not work when:
1 The firewall is active (turn the firewall off in menu 21.2 or create a firewall rule to allow
access from the WAN).
2 You have disabled Telnet service in menu 24.11.
3 You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet
service.
4 The IP you entered in the Secured Client IP field in menu 24.11 does not match the
client IP. If it does not match, the ZyWALL will disconnect the Telnet session
immediately.
5 You have an SMT console session running.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit
Table 212 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or
service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).