ZyXEL Communications 2 Plus Network Card User Manual


 
Chapter 39 System Information & Diagnosis
ZyWALL 2 Plus User’s Guide
538
3 There are three commands in Menu 24.1 - System Maintenance - Status. Entering 1
drops the WAN connection, 9 resets the counters and [ESC] takes you back to the
previous screen.
Figure 366 Menu 24.1: System Maintenance: Status
The following table describes the fields present in Menu 24.1 - System Maintenance -
Status. These fields are READ-ONLY and meant for diagnostic purposes. The upper right
corner of the screen shows the time and date according to the format you set in menu 24.10.
Menu 24.1 - System Maintenance - Status 07:34:20
Mon. Sep. 04, 2006
Port Status TxPkts RxPkts Cols Tx B/s Rx B/s Up Time
WAN 100M/Full 4860 17092 0 0 128 1:47:08
LAN 100M/Full 9021 10280 0 716 128 1:50:12
DMZ 100M/Full 229 0 0 0 0 1:50:12
WLAN 100M/Full 108 0 0 0 0 1:50:12
Port Ethernet Address IP Address IP Mask DHCP
WAN 00:13:49:00:00:02 172.23.37.34 255.255.255.0 Client
LAN 00:13:49:00:00:01 192.168.1.1 255.255.255.0 Server
WLAN 00:13:49:00:00:04 0.0.0.0 0.0.0.0 None
DMZ 00:13:49:00:00:03 10.2.3.4 255.0.0.0 None
System up Time: 1:50:17
Press Command:
COMMANDS: 1-Drop WAN 9-Reset Counters ESC-Exit
Table 207 System Maintenance: Status Menu Fields
FIELD DESCRIPTION
Port This field identifies a port (WAN, LAN, DMZ or WLAN) on the ZyWALL.
Status For the LAN, DMZ, and WLAN Interfaces, this displays the port speed and duplex
setting.
For the WAN port, it displays the port speed and duplex setting if you’re using
Ethernet encapsulation and Down (line is down or not connected), Idle (line (ppp)
idle), Dial (starting to trigger a call) or Drop (dropping a call) if you’re using
PPPoE encapsulation.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Cols This is the number of collisions on this port.
Tx B/s This field shows the transmission speed in Bytes per second on this port.
Rx B/s This field shows the reception speed in Bytes per second on this port.
Up Time This is the total amount of time the line has been up.
Ethernet Address This is the MAC address of the port listed on the left.
IP Address This is the IP address of the port listed on the left.
IP Mask This is the IP mask of the port listed on the left.