Filter
Top Products
Chapter 40 Firmware and Configuration File Maintenance
ZyWALL 2 Plus User’s Guide
556
1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your ZyWALL.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “bin” to set transfer mode to binary.
6 Find the “rom” file (on your computer) that you want to restore to your ZyWALL.
7 Use “put” to transfer files from the ZyWALL to the computer, for example, “put
config.rom rom-0” transfers the configuration file “config.rom” on your computer to the
ZyWALL. See earlier in this chapter for more information on filename conventions.
8 Enter “quit” to exit the ftp prompt. The ZyWALL will automatically restart after a
successful restore process.
40.4.2 Restore Using FTP Session Example
Figure 383 Restore Using FTP Session Example
Refer to Section 40.3.5 on page 552 to read about configurations that disallow TFTP and FTP
over WAN.
40.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter “y” at the following screen.
Figure 384 System Maintenance: Restore Configuration
2 The following screen indicates that the Xmodem download has started.
Figure 385 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC